Clamp On Fish Rod Holder. Deluxe Manometer Fuel Injection Pressure Tester Gauge Kit system 0-140 psi. The uniquely designed 3-1/2 gauge has a special expanded 1lb. Increment dual dial for accurate reading, with a 140 PSI /10 bar scale. It also has a relief valve and 6 ft. Of tubing to relieve the pressure and fuel safely. Also allows checking
» Read moreK&N Performance Cold Air Intake System. A high-density polyethylene (HDPE) rotationally-molded tube helps increase the volume of airflow to your engine, and provides a guaranteed increase in horsepower and torque. These systems are paired with a washable, reusable High-Flow Air Filter featuring oiled cotton filter media. The oversized, conical design allows you to go up to 100,000 miles between filter
» Read moreK&N AirCharger Cold Air Intake System. The K&N AirCharger 63-1564 air intake system replaces your vehicles restrictive factory air filter and air intake housing. K&N intakes are designed to dramatically reduce intake restriction as they smooth and straighten air flow. This allows your vehicles engine to inhale a larger amount of air than the factory air filter assembly. More air
» Read moreDelphi Fuel Injection to Carburetor Conversion Fitting Kit for Harley-Davidson. BRAND NEW IN THE BOX PLEASE NOTE THAT ALL PHOTOS ARE FOR REFERENCE ONLY. Once installed, any Pingel 22mm valve can be used. The introduction of larger bore engines has surpassed the stock fuel injections ability to deliver adequate fuel. This kit replaces the factory tank fittings allowing the use
» Read moreOur aftermarket in bed fuel tanks bolt to the bottom of the frame in-between the frame rails after the rear axle. Removal of the bed may be necessary for installation. 255lp/h pump supports up to 600hp! Can be used with FiTech, Holley, or Edelbrock fuel injection kits as well as LS swaps. Fits between the frame rails. 187-thick mounting brackets
» Read moreHolley Sniper 650HP EFI Conversion Kit. The new Sniper EFI is Holley’s answer to the self-learning EFI market offerings of Edelbrock, FiTech, and others. Put an end to cold start issues, hesitations, vapor lock, flooding, and most of all, TUNING. Perfect for street rods, muscle cars, off road trucks or nearly any carbureted vehicle. Upgrade to the Sniper EFI and
» Read moreK&N Blackhawk Cold Air Intake System. The K&N 71-1562 Blackhawk Induction Air Intake System is a free-flowing, mandrel-bent aluminum tube air intake system that is guaranteed to gain power. It replaces your vehicles restrictive factory air filter and air intake housing. This low restriction air intake allows your engine to inhale a larger amount of air than it would from
» Read moreK&N FIPK Performance Cold Air Intake System. Gain a guaranteed increase in horsepower and torque with a K&N® cold air intake system featuring a mandrel-bent aluminum intake tube. Each system is paired with a washable, reusable High-Flow Air Filter featuring oiled cotton filter media. The oversized, conical filter design allows you to go up to 100,000 miles between filter services
» Read more
