Corvair 65-69 Car, 2-TBI Electronic Fuel Injection and Ignition Kit
Corvair 65-69 Car, 2-TBI Electronic Fuel Injection and Ignition Kit. 2 Throttle Body Injection. Performance, Economy, and Durability. The 2 Throttle body Injection system can be used on ALL Corvairs except the turbo version. The Carburetors are replaced with Brown EFI Throttle body injection units (TBIU). These TBIUs are Corvair Carbs that have been cleaned, new throttle shafts installed, and modified for higher airflow. These kits use your existing Corvair throttle linkage and distributor that is easily modified for a trouble-free, adjustable computer-controlled ignition system. The throttle body injection units must use the insulators to ensure the proper height of the TBIs for linkage clearance and leverage angles. Each Corvair engine type will have its own tune and we plan to constantly update the tune with the community of EFI tuners. User modification of engine tune can be accomplished with a laptop for those wanting different performance parameters those originally designed. We use one (1) high-pressure injector per TBIU which highly atomizes the fuel spray, even at low engine speeds. The TBIUs is slightly taller than the original Carbs by approx 1/2 to allow for air cleaner clearance and maintain optimum injector angle. The 2 TBI kit can also be used on the 140 HP model, but will need block-off plates (which we can supply) and will require the 140×2 TBI ECM tune. The electronic idle control system (ICS) advances the idle when the engine is cold, or as needed on engines equipped with an Automatic transmission. We program the ECMs for the middle of the road engine setups, so some engine combinations will require user adjustment with a laptop. Ignition : This kit uses your Corvair modified distributor, standard coil, and a GM ignition module for a dependable and simple EFI system. Your standard coil works just fine, but for those who want a little more spark, we recommend the Flame Thrower 40011 40k coil. These upgraded coils provide more than enough spark for Corvair engines except for extreme setups. Using this type of setup, you can create custom ignition curves and factor in things like temp. Provide spark plug wires for this kit as it uses standard Corvair plug wires. If you plan to install Air Conditioning, the AC pulley will interfere with the Trigger wheel and will require you to send your Harmonic Balancer to us for modification for a special type of trigger wheel. Kit includes all items from the fuel pressure regulator to the engine. Fuel Pump and fuel return adapter are NOT included in the kit, but available at additional cost. 1 ea Throttle body assembly w/Injector and TPS 1 ea Throttle body assembly w/Injector, ICS and ICS Solenoid 1 ea PVC Hose to MAP sensor Tee (3/8 x 1/4). Optional for cross-over pipe that does not have nipple. 1 ea Fuel Line Passenger Side 1 ea Fuel Line Drivers Side 1 ea Fuel Line T to Tunnel Line 1 ea Fuel Pressure Regulator/Filter, 58 lbs with 5/16 hose barb 1 ea Fuel Pressure Regulator to hose adapter (3/8 x 5/16) 1 ea Fuel Pressure Regulator to hose adapter (5/16 x 5/16) 1 ea Map Sensor, GM Type (Mounted to Control Panel) 1 ea Narrow Band O2 Sensor or Wide Band O2 Sensor (you must specify at time of order) 1 ea Head/Engine Temp Sensor 1 ea Fuel pump block-off with O-Ring 1 ea Wiring Harness with Relays 1 ea ECM Computer (programmed and user adjustable) 1 ea USB to 2.5mm ECM to Laptop Cable (not shown in pic above) 1 ea Ignition Module w/heat sink 1 ea 36-1 Trigger Wheel w/bolts and spacers 1 ea Crank Sensor Bracket 1 ea Crank Sensor 1 ea Diode for Alternator Feedback 2 ea 140 HP Block-offs. 2 ea Carburetor base core required. Ignition modules are reused GM modules that have been thoroughly tested. Cores: Send your cores (Early models are preferred) when you order to allow time for the modifications to these items and avoid delays. Your cores must be in reasonably good shape and must have a fairly straight Bell Crank, a throttle plate, and a throttle shaft that is not binding. A core charge will be charged for each unusable core. The item “Corvair 65-69 Car, 2-TBI Electronic Fuel Injection and Ignition Kit” is in sale since Friday, November 27, 2020. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Air Intake & Fuel Delivery\Fuel Inject. Controls & Parts”. The seller is “corvair-efi” and is located in Anderson, South Carolina. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Panama, Jamaica, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay.
- Manufacturer Part Number: B-13113
- Brand: Brown EFI
- PSI: 58
- Fitment Type: Performance/Custom
- Type: Fuel Injector Installation Kit
- Warranty: 1 Year
- Country/Region of Manufacture: United States
- Mounting Hardware Included: Yes