Holden 304 Stack ITB Fuel Injection Racing Manifold KIt EFI Hardware
This complete Holden 304, Stack Injection ITB kit is supplied with 50mm Ram Tubes and Throttles and is capable of flowing up to 570HP. NOTE: This is the potential flow rate of the Throttle Bodies, and does not indicate the power that your engine will produce as there are many other factors that will determine the max power produced by your engine. Kit Includes: 4 x 50mm IDF Style Throttle Bodies 2 x Joiner Balancers – Adjustable 2 x Throttle Levers with Full Throttle Stops and Idle Adjustments 1 x Bell Crank – Spring Loaded 8 x 90mm Long Velocity Stacks (Ram Tubes) 2 x Fuel Rails – With Mounts 1 x 304 V8 Stack Injection Manifold. Using an appropriate ECU and Distributor you can run your V8 in sequential injection mode, gaining lower fuel consumption and better drivability than batch fire fuel injection. This V8 Stack Fuel Injection System is supplied unanodized. TOTAL HEIGHT: 185mm – from Velocity Stack to Top of Intake Manifold Port. TPS Mounting and Drive – uses an 8mm shaft with 6mm across the “D”. The mounting holes PCD for the TPS is 32mm. BROUGHT TO YOU BY EFI HARDWARE. In the past, 12° throttle plates were the industry standard. The problem with 12° throttle plates, is that as the plates are moved off the closed position, the change in airflow is huge. It makes it very difficult to drive smoothly at lower throttle openings. 6° throttle plates improve off idle and cruise driveability making your vehicle far more enjoyable to drive. The item “Holden 304 Stack ITB Fuel Injection Racing Manifold KIt EFI Hardware” is in sale since Monday, June 16, 2014. This item is in the category “Vehicle Parts & Accessories\Car & Truck Parts\Performance Parts\V8″. The seller is “efihardware” and is located in MITCHAM, Victoria. This item can be shipped worldwide.